Bronco L6-300 4.9L VIN Y 1-bbl (1983)
Counter Gear: Service and Repair
DISASSEMBLE
Disassembled View Of Warner T-19B & T-19D 4-speed Manual Transmission
1. Remove dummy shaft and bearing rollers from countershaft gear.
2. Remove bearing spacers and center spacer from gear.
ASSEMBLE
1. Slide long bearing spacer into countershaft gear bore, then insert well greased dummy shaft into spacer.
2. Install one bearing spacer, then 22 pilot rollers in gear bore, While holding gear in a vertical position.
3. Install second spacer, then the remaining 22 rollers and spacer.
4. Apply suitable grease to face of large thrust washer, then hold washer against face of countershaft gear and invert assembly. Install rollers, spacers
and thrust washer in opposite end of gear.
