Bronco V8-351 5.8L VIN H 4-bbl HP (1984)
Dealers are obligated to perform this recall service promptly following presentation of the vehicles by the owners. United States law requires that we
advise owners in the Commonwealth of Puerto Rico and certain territories of the procedure to be followed by them in informing the National Highway
Traffic Safety Administration, if the defect is not corrected without charge within a reasonable time after the vehicle is brought in. This notice is included
in the owner letter (copy attached) to be sent to owners in Puerto Rico, Virgin
Islands, American Samoa, Canal Zone, Guam and the Northern Mariana Islands. It is also important, however, that you promptly report (to your
supervising location or Wixom) any instances in which an owner will not allow you to complete this recall because of objections to delays in scheduling,
or for any other reason.
TECHNICAL INSTRUCTIONS:
1.
Park the vehicle. Turn the engine OFF. Set the parking brake.
2.
Raise the engine hood and position the support rod.
SAFETY RECALL 480 ATTACHMENT 1
3.
Inspect the fuel supply hose connection to the fuel pump for fully seated hose and proper positioning of the hose clamp as shown in the
Attachment.
4.
If the hose clamp (380882-S100) is mispositioned, use a hose clamp tool or pliers to position the clamp between the two beads on the fuel pump
inlet nipple. NOTE: Be sure the hose is fully seated on the nipple before positioning the clamp.
PARTS REQUIREMENTS.
No additional parts are required for this recall.
Labor Allowances, Reporting of Completion and Owner Letter Information
