Bronco Full Size V8-302 5.0L (1986)
Compressing Pin Tabs
7. Use needle nose pliers to compress the outboard end of the pin while prying at the same time with the screwdriver, until tabs slip into the spindle
groove.
8. Place one end of a punch (approximately 7/16 inch diameter) against the end of the caliper pin and drive the caliper pin out of the caliper slide
groove.
9. Repeat removal procedure for lower pin.
10. Remove the caliper from the rotor. If the caliper is to be removed for service, remove the brake hose from the caliper. If the caliper is not going to
be removed, secure it to the vehicle to avoid damage to the brake hose.
Caliper Inlet Block
11. Remove the outer brake pad. Remove the anti-rattle clips and the inner brake pad.
For additional information see Removal Notes. See: Fundamentals and Basics
