Bronco Full Size V8-302 5.0L (1986)
6. Tap the pin on the outboard end with a hammer. Continue tapping the pin inward until the retention tabs on the sides of the pin contact the spindle
face. Repeat procedure for the lower pin.
Correct Caliper Pin Installation
CAUTION: During the installation procedure do not allow the tabs of the caliper pin to be tapped too far into the spindle groove. If this happens
it will be necessary to tap the other end of the caliper pin until the tabs snap into place. The tabs on each end of the caliper pin must be free to
catch on the spindle flanks.
7. If removed, install the brake hose to the caliper and perform brake bleeding procedures.
8. Install the wheel and tire assembly.
9. Lower the vehicle, check the brake fluid level and fill as necessary. Check brakes for proper operation.
