Bronco Full Size V8-302 5.0L (1986)
Fig. 4 Checking Brake Lining Clearance
3.
Reverse tool and adjust shoes until they contact gauge, ensuring that gauge is parallel to vehicle and at centerline of axle, Fig. 4. Holding
automatic adjusting lever aside, rotate adjusting screw as necessary.
4.
Install drums, wheels and retaining nuts, then complete adjustment by applying brakes several times while driving vehicle in reverse.
5.
Check brake operation by making several stops in forward gear. Repeat step 4, if necessary.
With Drums Installed
1.
Raise and support rear of vehicle.
2.
Remove cover from adjusting hole located at bottom of backing plate.
Fig. 5 Adjusting Rear Drum Brakes
3.
Using a small screwdriver to hold adjusting lever away from star wheel, rotate adjusting screw star wheel until brake shoes are locked against
drum, Fig. 5.
4.
Back-off brake adjusting screw approximately 10 to 12 notches so that brake drum rotates freely without drag. If brake drum does not rotate freely,
remove drum and clean and inspect drum brake components.
5.
After adjusting both drum brakes lower vehicle and apply brakes several times to position brake shoes.
6.
Road test vehicle to ensure brakes operate properly.
