Bronco Full Size V8-302 5.0L (1986)
Brake Band And Drag Sleeve Assembly
6. Assemble one of the two tangs of the brake band on each side of plastic outer cage that is located in the window of the steel inner cage. It will be
necessary to tip these parts to engage tangs in this position as the drag sleeve is positioned against the face of the cam follower.
7. Install washer and snap ring.
INSTALLATION
1. Remove excessive grease from hub-lock and hub splines prior to installation.
2. Start hub lock assembly into hub making sure large tangs are lined up with lock washer and the outside diameter and inside diameter splines are in
line with the hub and axle shaft splines.
3. Install retainer ring by closing the ends with needle nose pliers and at the same time push hub lock assembly into the hub.
4. Install seal bridge retainer (small metal stamping) with narrow end first.
6. Install rubber seal over cap assembly.
7. Install cap assembly (make sure ball bearing, spring, bearing race and retainer are in place).
8. Tighten the five capscrews to 4.5-5.6 Nm (40-50 lb in) using the following sequence: tighten one, skip one, etc.
