Bronco Full Size V8-302 5.0L (1986)
Bearing Retainer Installation
1. Wash the cap bearing, race and retainer assembly in cleaner solvent and thoroughly dry the components. Repack the bearing with a lithium base
grease. Refer to illustration for proper positioning of the bearing on the race.
Washer And Snap Ring
2. Remove the snap ring and flat washer from the inner end of the hub lock assembly.
3. Pull the hub sleeve and attached parts out of the drag sleeve.
Brake Band And Drag Sleeve Assembly
4. Tip the drag sleeve to unlock the tangs of the brake band and remove the drag sleeve assembly.
NOTE: Never remove the brake band from the drag sleeve. Wash in cleaner solvent and air dry the drag sleeve and brake band. Lubricate the
brake band and drag sleeve assembly with 1.5 grams (0.05 oz.) of Automatic Hublock Grease, or equivalent. Work the lubricant over the spring
and the area of the drag sleeve under the spring.
5. The body assembly (excluding cap assembly, and brake band and drag sleeve assembly) should be dipped in Automatic Transmission Fluid, or
equivalent and permitted to drip dry for a few minutes before proceeding with re-assembly.
