Bronco II 2WD V6-177 2.9L (1986)
The new alignment adjusters are similiar to the current camber adjusters. The one exception is the rotational position of the adjuster sleeve to obtain the
desired adjustment.
ADJUSTER SLEEVE APPLICATION FOR RANGER BRONCO II, BRONCO, AND F-150
1.
Measure and record the alignment readings.
2.
Determine what alignment adjuster sleeves are on the truck.
NOTE:
IF AFTERMARKET ADJUSTER SLEEVES HAVE BEEN INSTALLED, IT WILL BE NECESSARY TO FIND OUT WHAT CASTER
AND CAMBER SLEEVES WERE USED.
If the adjuster sleeve is not marked or cannot be identified, install a 0 degree adjuster sleeve to use as a reference point.
3.
Determine what adjuster sleeve change is required. Take your desired alignment (what you want to end up with) and compare it to the readings
taken in Step 1 to determine the change.
4.
Pick the adjuster sleeve that will get you the closest to the desired alignment.
5.
Install and position the adjuster sleeve, Figure
1.
Refer to the appropriate Light Truck Shop Manual, Section 14-21 for service details. See the following caster adjuster sleeve chart and
camber adjuster sleeve chart for the correct service parts.
CAMBER ADJUSTER SLEEVE APPLICATION CHART
SERVICE PART
APPLICATION
VALUE
NUMBER
F Series/Bronco -
0~
E0TZ-3B440-A
4x4
1/2~
E0TZ-3B440-B
1~
E0TZ-3B440-C
1-1/2~
E0TZ-3B440-D
Ranger/ Bronco II -
0~
E3TZ-3B440-A
4x4
1/2~
E3TZ-3B440-B
1~
E3TZ-3B440-C
1-1/2~
E3TZ-3B440-D
ADJUSTER ORIENTATION CHART
CAMBER CASTER CAMBER CASTER
POSITION
LEFT
LEFT
RIGHT
RIGHT
OF SLOT
SIDE
SIDE
SIDE
SIDE
45~
+1~
-1~
-1~
-1~
135~
-1~
-1~
+ 1~
-1~
225~
-1~
+1~
+1~
+1~
315~
+1~
+1~
-1~
+1~
6.
Recheck the alignment to make sure you arrived at the desired values.
CASTER WEDGE APPLICATION: F-250/350 4X4
The caster angle on the F-250 4x4 can be adjusted by inserting a wedge between the spring and the axle. Refer to the appropriate model year Light Truck
