Bronco II 2WD V6-177 2.9L (1986)
Figure 4
7.
Install gasket around handle assembly, Figure 4. If vehicle is not equipped with power windows/door locks, the trim panel can be reinstalled. If
vehicle is equipped with power windows/door locks, continue with Step 8.
8.
Using the pre-cut slit in the E7TZ-14521-A foam gasket, slide gasket down over wire harness where it comes through the watershield until it is
centered, Figure 4.
NOTE:
Be sure gasket rests on taped portion of wire harness.
9.
With foam gaskets in place, reinstall trim panel.
PART NUMBER
PART NAME
CLASS
E7TZ-14521-A
Foam Seal
C
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Eligible under Basic Warranty Coverage
OPERATION: SP871709A
TIME:
0.6 Hr. - Without power windows/ door locks
0.7 Hr. - With power windows/ door locks
DLR. CODING: Basic Part No. 7023942 Code:48
