| General Procedures | | -
Body dimensions, vehicle front - All dimensions with tolerance ± 3mm. All dimensions were determined starting from the centre of each hole or panel edge using a symmetrically adjusted measuring gauge.
- 1 - 2 = 443 mm; 1 - 3 = 507 mm; 1 - 4 = 733 mm; 1 - 5 = 1,410 mm; 1 - 6 = 1,485 mm; 1 - 7 = 1,485 mm; 1 - 8 = 1,649 mm.
| | | -
Body dimensions, side view - All dimensions with tolerance ± 3mm. All dimensions were determined starting from the centre of each hole or panel edge using a symmetrically adjusted measuring gauge.
- 11 - 12 = 1,374 mm; 13 - 14 = 873 mm; 15 - 16 = 1,082 mm; 17 - 18 = 1,229 mm; 19 - 20 = 1,130 mm; 21 - 22 = 763 mm.
- Measuring points 11, 12, 15, 16, 17, 18 and 19 are measured in the curve and represent the greatest distance to the measuring point opposite.
| | | -
Body dimensions, rear - All dimensions with tolerance ± 3mm. All dimensions were determined starting from the centre of each hole or panel edge using a symmetrically adjusted measuring gauge.
- 23 - 24 = 1,079 mm; 25 - 26 = 972 mm; 27 - 28 = 1,284 mm.
| | | -
Passenger compartment, body dimensions - All dimensions with tolerance ± 3mm. All dimensions were determined starting from the centre of the welded flange using a symmetrically adjusted measuring gauge.
- 29 - 30 = 1,445 mm; 31 - 32 = 1,461 mm; 33 - 34 = 1,445 mm.
| | |
