Ford Workshop Service and Repair Manuals

Torque Converter Leak Check Tool and Gasket

307-421

1. Clean the outside surface of the torque converter.

2. Install the special tool onto the converter hub.

3. 

   WARNING:Always follow correct safety procedures while using a press. Failure to follow these instructions may result in personal injury.
   Install the torque converter with the special tool installed onto the arbor press.
   • Apply only enough force from the press to seal the special tool into the torque converter.

4. 

   CAUTION:Use only clean, dry shop air.
   Connect the airline to the special tool and apply air pressure.

5. With air pressure applied to the valve, inspect for leaks at the converter hub, the seams and the studs. A soap bubble solution can be applied around these areas to aid in the diagnosis. If any leaks are present, install a new converter.

6. Remove the air hose. Release the pressure, and then slowly release the press. Remove the converter. Remove the special tool.