| Removal and Installation | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| 2. Remove the components in the order indicated in the following illustration(s) and table(s). 3 - Rear door trim panel pull handle cover 4 - Rear door trim panel pull handle retaining bolts 3. To install, reverse the removal procedure. | | -
Initialize the door window motors.
For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
| Removal Details Item 1 : Rear door trim panel latch remote control handle bezel | | -
NOTE:Do not place excessive strain on the rear door trim panel power window switch wiring harness). Detach the rear door trim panel latch release handle bezel (rear door trim panel power window switch shown removed for clarity. - Operate the Rear door latch release handle.
- Detach the rear door latch release handle bezel from the rear door latch release handle.
| Item 2 : Rear door trim panel power window switch | | -
Remove the rear door trim panel power window switch. - Detach the power window switch from the rear door trim panel latch remote control handle bezel.
- Disconnect the rear door power window switch electrical connector.
| Item 5 : Rear door trim panel | | -
NOTE:Detach the rear door trim panel starting from the top front corner down to the bottom rear corner of the door before the rear door trim panel is completly detached. NOTE:Do not place excessive strain on the rear door trim panel tweeter speaker wiring harness. Detach the rear door trim panel. | Item 6 : Rear door trim panel tweeter speaker electrical connector | | -
Disconnect the rear door trim panel tweeter speaker electrical connector. | Item 6 : Rear door trim panel tweeter speaker | | -
Remove the rear door trim panel tweeter speaker. - Release the locking tangs.
| Item 7 : Rear door trim panel blind assembly | | -
CAUTION:Take extra care not to damage the clips. Detach the rear door trim panel blind assembly from the rear door trim panel. | | | -
- Raise the rear door trim panel blind.
- Move the rear door trim panel blind clip to the vertical position.
- Lower the rear door trim panel blind and feed through the rear door trim panel.
| Item 8 : Rear door trim panel retaining clips | | -
Remove the rear door trim panel retaining clips. - Release the rear door trim panel retaining clip retainer locking tang.
- Remove the rear door trim panel retaining clip.
| Installation Details Item 8 : Rear door trim panel retaining clips | | -
NOTE:Make sure that the rear door trim panel retaining clips are in the closed position. Install the rear door trim panel retaining clips to the rear door trim panel retaining clip retainer. | Item 6 : Rear door trim panel tweeter speaker | | -
CAUTION:Make sure that the locating tang on the top of the rear door tweeter speaker is correctly aligned with the rear door trim panel groove. Failure to follow this instruction may cause damage to the rear door trim panel. Install the rear door trim panel tweeter speaker. | | 
