Removal and Installation NOTE:Make sure the roof opening panel is in the closed position. | -
Remove the headliner. For additional information, refer to: Headliner - Vehicles With: Sliding Roof Opening Panel. | 2. Remove the components in the order indicated in the following illustration(s) and table(s). 3. To install, reverse the removal procedure. Removal Details Item 1 : Roof opening panel drain hoses | -
Detach the drain hoses from the roof opening panel. | Item 3 : Roof opening panel retaining clips | -
CAUTION:The roof opening panel front retaining clip is fixed to the roof opening panel frame and is not a service item. With the aid of another technician, compress the legs of the retaining clips and lower the roof opening panel. | Item 4 : Roof opening panel | -
Loosen the roof opening panel frame locking clamp retaining bolt on both sides. | Installation Details Item 4 : Roof opening panel | -
NOTE:This step should only be carried out if installing a new roof opening panel. Loosen the roof opening panel frame locking clamp retaining bolt on both sides. | | -
Tighten the roof opening panel frame locking clamp retaining bolt on both sides. - Position the clamp.
- Tighten the retaining bolt.
| Item 2 : Roof opening panel retaining bolts | -
NOTE:Do not fully tighten the retaining bolts at this stage. NOTE:The roof opening panel must be correctly located on the retaining clips before tightening the retaining bolts. With the aid of another technician, install the roof opening panel. | | -
Tighten the retaining bolts in the sequence shown. | |