| Removal and Installation | | -
Remove the headliner.
For additional information, refer to: Headliner - Vehicles With: Sliding Roof Opening Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
| 2. Remove the components in the order indicated in the following illustration(s) and table(s). 1 - Roof opening panel motor electrical connector 3. To install, reverse the removal procedure. | | -
Carry out the initial roof opening panel motor initialization procedure.
For additional information, refer to: Roof Opening Panel Motor Initialization (501-17 Roof Opening Panel, General Procedures).
| Installation Details Item 2 : Roof opening panel motor CAUTION:The roof opening panel motor must not be installed at this stage. | | -
Starting at the rear of the roof opening panel, remove the roof opening panel guide arm covers (left-hand side shown). - Release the lower clip.
- Release the upper clip.
| | | -
CAUTION:The guide pins must be aligned centrally in the flat area of the roof opening panel guide arm as shown. Check the alignment of the left-hand and right-hand cable guide pins (left-hand side shown). | | | -
Adjust the left-hand cable guide pin if necessary. - Using a suitable screwdriver, move the cable in the direction required.
| | | -
Adjust the right-hand cable guide pin if necessary. - Using a suitable screwdriver, move the cable in the direction required.
| | | -
NOTE:This step is not necessary when installing a new roof opening panel motor. With the aid of another technician, support the overhead console and connect the roof opening panel control switch electrical connector. | | | -
NOTE:This step is not necessary when installing a new roof opening panel motor. Connect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
CAUTION:This step must be carried out if installing a previously used roof opening panel motor. NOTE:This step is not necessary when installing a new roof opening panel motor. Carry out the erasing roof opening panel motor initialization procedure.
For additional information, refer to: Roof Opening Panel Motor Initialization (501-17 Roof Opening Panel, General Procedures).
| | | -
NOTE:This step is not necessary when installing a new roof opening panel motor. Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| | | -
NOTE:This step is not necessary when installing a new roof opening panel motor. Disconnect the roof opening panel control switch electrical connector. | | | -
Install the roof opening panel motor. | | | -
NOTE:An audible click can be heard when the lower edge of the guide arm cover is correctly located. Starting at the front of the roof opening panel, install the guide arm covers (left-hand side shown). - Install the upper clip.
- Install the lower clip.
| |
