Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
disconnection of fitting and discard copper washer.
^
If gas flow continues for more than 10 seconds, retighten fitting and call GFI Customer Service Hotline at 1-800-667-4275 for additional
assistance.
9.
Remove compuvalve inlet line from regulator outlet port. Discard line and copper washers. To gain clearance to the inlet line, it may be necessary
to dismount regulator from underbody of vehicle.
10.
Disconnect outlet line from quarter turn valve. Refer to Figure 9.
11.
Install 3/8-inch adapter (from GFI vent kit N1-185) to open port of quarter turn valve. Refer to Figure 9. Tighten adapter until a sharp increase in
torque is felt.
12.
Install vent hose (from GFI vent kit) to 3/8-inch adapter. Refer to Figure 9. Tighten elbow of vent hose until a sharp increase in torque is felt.
13.
Secure other end of vent hose to underbody of vehicle. See Figure 9.
14.
Lower vehicle.
15.
Move vehicle to approved CNG vent stack or venting station.
