Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
CAUTION: Proper installation of ignition wires is critical to vehicle operation. If one ignition wire is not properly installed on the spark plug or
ignition coil, both spark plugs connected to that ignition coil may not fire properly.
1. Whenever an ignition wire is removed from a spark plug or ignition coil, or a new ignition wire is installed, apply Ford Silicone Dielectric
Compound D7AZ-19A331-A (Motorcraft WA-10) or equivalent meeting Ford specification ESE-M 10171-A to the boots prior to installation
using a small, clean tool. Coat the entire interior surface of the boots.
2. Install each ignition wire to the proper terminal on the ignition coil. The terminals on the ignition coil are numbered. Make sure the boots are fully
seated and that both ignition coil boot locking tabs are engaged.
3. Route ignition wire through ignition wire separators and close ignition wire separators.
4. Connect ignition wires to spark plugs.
