Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
Seat Belt Retractor: Service and Repair
Front Seat Belt, Retractor and Tongue
REMOVAL
NOTE: Seat Belt Bolt Bit T77L-2100-A (#50 Torx[r]) should be used for safety belt bolt removal and installation on front outboard safety belts. A
metric socket is necessary to remove or install inboard front safety belt buckle ends.
1. Remove front seat cushion side shield.
2. Remove bolt retaining front safety belt retractor and tongue to front seat frame.
3. Remove B-pillar trim.
4. Remove door scuff plates/lower body center pillar.
5. Remove and discard front safety belt guide retaining nut. Retaining nut is not reuseable.
6. Remove guide retaining screw.
7. Slide safety belt through B-pillar trim.
