Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
Impact Sensor: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect positive battery cable and wait one minute for back-up power supply energy to be depleted.
3. Remove two screws and grille from grille opening panel reinforcement.
4. Remove two screws and RH and LH parking lamps.
5. Remove 12 screws from radiator grille opening panel reinforcement.
6. Disconnect RH or LH primary crash sensor electrical connector.
7. Remove three retaining screws and RH or LH primary crash front air bag sensor and bracket from radiator support.
INSTALLATION
1. Position RH or LH primary crash front air bag sensor and bracket to radiator support and secure with three retaining screws. Tighten screws to
9-13 Nm (80-115 lb in).
2. Connect RH or LH primary crash sensor electrical connector.
3. Position radiator grille opening panel reinforcement and secure with 12 screws. Tighten screws to 5-7 Nm (44-62 lb in).
4. Install RH and LH parking lamps and secure with two screws. Tighten screws to 5-7 Nm (44-62 lb in).
5. Install radiator grille and secure with two screws. Tighten screws to 5-7 Nm (44-62 lb in).
6. Reconnect battery positive cable.
7. Reconnect battery ground cable.
8. Prove out air bag system.
