Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
Manual Shaft Retaining Pin Removal
7. Remove manual valve detent lever shaft as shown in the Manual Valve Detent Lever Shaft Retaining Pin Removal image and the manual shaft
retaining pins as shown in the Manual Shaft Retaining Pin Removal image. Protect transaxle case with a wooden spacer during pin removal, and
discard old pins.
8. Remove manual valve detent lever assembly and shaft, then the manual control seal from transaxle case. Discard seal.
9. Remove line pressure port plug and oil tube connector from transaxle case, then inspect oil tube connector seal.
10. If necessary, remove driven sprocket bearing from transaxle case as follows:
Driven Sprocket Bearing Removal Tool Installation