Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
ASSEMBLE
1. Install retaining ring and forward one-way clutch retainer.
NOTE: Retainer tabs must face down.
2. Assemble forward one-way clutch sprag assembly and end caps.
NOTE: Ensure end caps are installed in their original positions.
3. Using sprag replacer tool No. T94P-7700O-J or equivalent, install sprag assembly and end caps in outer race, then invert outer race and sprag
assembly and install on forward one-way clutch inner race.
NOTE: Lube grooves must face away from sun gear.
4. Install coast clutch hub and retaining ring.
NOTE: Retaining ring ends must point toward coast clutch hub.
5. With low/intermediate sun gear facing up, check operation of forward one-way clutch as follows:
Low/Intermediate Sun Gear Rotation
a. While holding outer race with one hand, rotate low/intermediate sun gear clockwise as shown in the Low/Intermediate Sun Gear Rotation
image. Sun gear should rotate independently of outer race and should drag slightly.
b. Rotate low/intermediate sun gear in opposite direction. Outer race should rotate with sun gear.
Low One-Way Clutch - With CD4E
DISASSEMBLE
