Contour L4-122 2.0L CNG DOHC VIN Z SFI (1996)
wires and pulling them out.
13.
Remove the selector lever knob screw and carefully pull off the knob while feeding the wires through the assembly. Use caution to avoid damage
to the wire insulation.
14.
Remove the lamp from the PRNDL bezel and remove the bezel.
15.
Install a new PRNDL bezel.
16.
Insert the lamp into the PRNDL bezel.
17.
While holding the 2-inch O/D wires firmly, push the selector knob on the selector lever. Be careful not to damage the wires. If the selector knob
does not slide on the selector easily, make sure the wires are routed correctly between the knob and lever.
18.
Install the shift knob attaching screw.
19.
Route the wires to the electrical connector.
20.
Connect the wires to the electrical connector in their original position.
21.
Connect the electrical connector to the selector lever assembly.
22.
Install the bezel assembly by reversing Steps 1-9.
NOTE:
Do not unlock the selector cable adjusting cap.
23.
Check indicator alignment (PRNDL indicator). If indicator does not align properly, loosen the shifter nuts and move shifter forward/backward as
required.
