Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
Code 311 - 320: Testing and Inspection
NOTE
KOEO refers to Key On Engine Off (KOEO)
KOER refers to Key On Engine Running (KOER)
DTC refers to Diagnostic Trouble Code (DTC)
DTCs should be diagnosed in the order they are received.
DTC 221
Spark timing error.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 222
Loss of ignition diagnostic monitor signal-right side.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 223
Loss of dual plug inhibit control.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 224
Powertrain control module detected coil 1, 2, 3 or 4 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 225
Knock not sensed during dynamic response test KOER.
KOER Hard Code .................................................................................................................................................................................... Go to DG1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/DG - Knock Sensor/DG1 - Check Sensor
Voltage Cycling
DTC 226
Ignition diagnostic monitor signal not received.
KOEO Hard Code .................................................................................................................................................................................... Go to NC2
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/NC - Ignition Diagnostic Monitor -- High
Data Rate/NC2 - Service Code 226: IDM Circuit Failure
DTC 232
Powertrain control module detected coil 1, 2, 3 or 4 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 238
Powertrain control module detected coil 4 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 241
Ignition control module to powertrain control module ignition diagnostic monitor pulsewidth transmission error.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 244
Cylinder Identification circuit fault present when cylinder balance test requested.
KOER Hard Code .................................................................................................................................................................................... Go to DR1
See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Pinpoint Tests/DR - Cylinder Identification (CID)
Sensor/DR1 - Will Engine Start
DTC 311
Secondary air injection system inoperative during KOER self-test (bank #1).
