Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
7.
Connect the fan motors.
8.
Proceed to Cooling Fan Assembly -- Installation.
2.0L Installation
1.
While an assistant positions the A/C accumulator and lines toward the transaxle, install the cooling fan assembly into the vehicle. See Figure 11.
2.
Raise and support the vehicle.
3.
Install the A/C accumulator mounting bracket bolts to the subframe, if equipped. Tighten the bolts to 11 Nm (8 lb-ft).
4.
On vehicles equipped with an automatic transaxle, install the transaxle cooling line routing clip onto the fan shroud.
5.
Install the lower air deflector.
6.
Lower the vehicle.
7.
Secure the engine cooling fan assembly to the radiator. Tighten the retainers to 4 Nm (35 lb-in).
8.
Secure the oxygen sensor wiring to the fan shroud.
9.
Connect the air conditioning compressor clutch cycling switch, if equipped.
10.
Connect then attach the power distribution harness connectors to the fan shroud.
11.
Install the ground wire to the radiator support.
12.
Connect the air conditioning compressor clutch connector, if equipped.
13.
Install the battery tray. Tighten the retainers to 10 Nm (89 lb-in).
14.
Install the ground wire to the fender apron. Tighten the screw securely.
15.
Secure the wiring routing clips to the battery tray. Use tie straps to secure the wiring as necessary.
