Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
1
Insert the oil feed ring into the oil feed flange.
2
Slide both components together onto the exhaust camshaft.
19. Thinly coat the camshaft bearing cap No. 5 with sealant.
20. Insert the camshafts.
-
Lubricate the valve tappets with engine assembly lubricant and insert them.
-
Lubricate the camshaft bearings with engine assembly lubricant.
-
Insert the intake camshaft.
1
Hold the oil feed flange upwards during installation of the exhaust camshaft.
2
Position the oil feed ring hole right to the top.
NOTE: Keep the oil feed flange away from the cylinder head when turning the flange to avoid damaging the gasket.
3
Turn the oil feed flange till the locating lug is in the installation position on the cylinder head.
21. Insert new exhaust camshaft oil seal.
22. NOTE: The numbering is on the outside of the camshaft bearing caps.
Insert the camshaft bearing caps.
NOTE: Make sure the upright seat of the exhaust camshaft oil seal during tightening process of camshaft bearing caps.
23. NOTE: Working evenly in several stages, screw in each bolt two turns at a time.
NOTE: Tighten in sequence.
