Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
Throttle Cable/Linkage: Adjustments
Without Traction Control
1. Remove one bolt and two nuts retaining engine air intake resonator to throttle body. Raise engine air intake resonator and place to the side.
2. Remove accelerator cable clip at accelerator cable bracket.
3. Fully depress and hold accelerator pedal with prop tool.
4. Pull on accelerator cable outer housing at accelerator cable bracket to obtain wide open throttle at throttle body. Observe position of throttle body
air valve. Install accelerator cable clip.
5. Remove accelerator pedal prop tool.
6. Observe position of throttle body air valve. Air valve should be closed and accelerator cable should deflect 1-3 mm (0.04-0.12 inch) midway
between accelerator cable bracket and throttle body lever.
7. Place engine air intake resonator into position on throttle body. Install one bolt and two nuts.
