Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
Throttle Cable/Linkage: Pinpoint Tests
Test A
^
Disconnect the cable end from the throttle body linkage.
^
Ensure the disconnected end of cable does not come in contact the with any of the surrounding parts.
^
Operate the pedal by hand.
^
Is the full pedal travel to WOT restricted by carpeting, floor mats, etc.?
YES -- Remove restriction to pedal travel.
NO -- Go to Test B. See: Test B
Test B
^
Cable end should remain disconnected.
^
Operate the pedal by foot.
^
Is the pedal operation smooth?
NOTE: The accelerator cable should not be lubricated and is not a serviceable item.
YES -- Refer to the throttle body diagnosis procedures.
NO -- Check the foot pedal assembly for free operation or check for worn or damaged cable by following Test C. See: Test C
Test C
^
Disconnect the cable from the cam at the throttle body.
^
Ensure the disconnected end of the cable does not come in contact with any of the surrounding parts.
-
Is the cable core wire kinked, frayed or damaged?
^
Pull the core wire through its entire travel from the pedal end and then from the throttle end.
^
Does it feel rough, sticky or restricted?
YES -- If Yes to any of the questions: Replace the cable.
NO -- If No to all of the questions: Cable is functioning properly. Refer to the Throttle Body / Testing and Inspection / Procedures or
adjust the carpet, floor mat, etc., as required.