Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
Air Bag Control Module: Service and Repair
REMOVAL
WARNING:
-
THE BACK-UP POWER SUPPLY ENERGY MUST BE DEPLETED BEFORE ANY AIR BAG COMPONENT SERVICE IS
PERFORMED. TO DEPLETE BACK-UP POWER SUPPLY ENERGY, DISCONNECT THE POSITIVE BATTERY CABLE AND
WAIT ONE MINUTE TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
-
THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO
AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE POSITIVE BATTERY CABLE MUST BE
DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.
1. Disconnect battery ground cable.
2. Disconnect positive battery cable and wait one minute for back-up power supply energy to be depleted.
3. Remove two screws and RH console front finish panel.
4. Depress tabs on air bag monitor bracket and slide air bag diagnostic monitor off bracket.
5. Disconnect air bag diagnostic monitor electrical wiring connectors and remove air bag diagnostic monitor.
INSTALLATION
1. Connect electrical wiring connectors to the air bag diagnostic monitor.
2. Position air bag diagnostic monitor to air bag monitor bracket and slide air bag diagnostic monitor into place. Ensure that tabs are locked in place.
3. Install RH console front finish panel and secure with two screws
4. Reconnect positive battery cable.
5. Reconnect battery ground cable.
6. Prove out air bag system.
