Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
through the desired tether anchorage hole in the package tray metal panel and up into the bottom rigid surface of the package tray trim panel.
2. From the top of the package tray trim panel, use the hole as a locator and cut a 30 mm (1-3/16 inches) slot centered on the pierced hole. Use a
utility knife to cut the rigid material. Use protective eye wear when cutting the slot in the trim.
3. Carefully slit and cut away just enough rigid material to allow the child safety belt anchor tether to be inserted through the slot as shown in the
following illustration.
WARNING:
-
THE TETHER ANCHOR BRACKET MUST BE BOLTED DIRECTLY TO THE SHEET METAL.
-
TIGHTEN THE ANCHOR TO 22-34 NM (18-25 LB-FT). OTHERWISE, THE SAFETY SEAT MAY NOT BE PROPERLY
SECURED AND THE CHILD MAY BE INJURED IN A SUDDEN STOP OR COLLISION.
-
THE THREADED HOLE IN THE TETHER ANCHOR OR RETAINING NUT HAS AN 8 MM METRIC THREAD. A WRENCH
WILL BE NEEDED TO TIGHTEN THE 8 MM BOLT TO THE REQUIRED TORQUE. SOME CHILD RESTRAINTS COME
WITH A NON-METRIC BOLT WITH A DIFFERENT THREAD. DO NOT USE A NON-METRIC BOLT AS IT MAY BE
IMPOSSIBLE TO SCREW IT ALL THE WAY INTO THE HOLE, RESULTING IN INADEQUATE RETENTION OF THE CHILD
RESTRAINT. USE ONLY THE METRIC ANCHOR BOLT SUPPLIED IN THIS KIT. IF YOU NEED A REPLACEMENT
METRIC BOLT OR RETAINING NUT, OR ASSISTANCE, ANY FORD DEALER WILL BE HAPPY TO ASSIST YOU.
4. Install the child safety belt anchor tether using the parts supplied in the tether anchorage kit.
