Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
b.
Assemble the input shaft and the output shaft together and fit them in the transmission housing (Figures 22 and 23).
c.
Measuring shim to be fitted to the input shaft is 1.00 mm.
d.
Cool the bearing cups. Heat the area of the housing to approximately 80°C (175°F) . Fit the measuring shim and the bearing cup in the
housing section at the clutch end (Figure 24). Using Bearing Cup Replacer T94P-7025-BH, Driver Handle T8OT-4000-W, and soft-faced
hammer.