Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
1-2 Synchronizer Orientation
2. Install 1-2 synchronizer with small collar facing outward, then position first gear synchronizer ring, needle bearing and first gear on shaft.
3. Using a suitable driver and press, carefully install pinion gear on output shaft splines and install a new snap ring.
NOTE: Pinion gear can only be installed in one direction.
4. Using a suitable driver and press, install tapered roller bearing on output shaft end, then install needle bearing, fifth gear, and reverse synchronizer
ring.
Synchronizer Components