Contour L4-122 2.0L DOHC VIN 3 SFI (1995)
j.
Leave the input shaft and output shaft together out of the transaxle housing (Figure 9).
k.
Remove the reverse gear idler shaft mounting and the reverse gear idler with the needle roller bearing and thrust washers.
3.
Disassemble the input shaft per the following Steps 3a-3e.
a.
Remove the bearing outer cups and shim of the input shaft in clutch housing using Puller T58L-101-B and Stator and Driven Sprocket
Bearing Remover T86P-70043-A (Figure 10).
