Contour V6-153 2.5L DOHC (1996)
Engine Mount: Service and Repair
Engine Support Insulators
REMOVAL
1. Disconnect battery ground cable, then remove engine air intake resonators.
2. Disconnect engine control sensor wiring connector from Mass Air Flow (MAF) sensor, then engine control sensor wiring from Intake Air
Temperature (IAT) sensor.
3. Remove engine air cleaner to body O-ring.
4. Remove engine air cleaner body and intake tube from bracket and intake tube and duct.
5. Remove air cleaner mounting bracket from engine and transaxle support insulator.
6. Install three bar engine support tool D88L-6000-A, or equivalent, to engine lifting eyes and support engine and transaxle.
Fig. 6 Engine & transaxle support insulator bolt removal. Automatictransaxle, manual transaxle similar
7. Remove engine and transaxle support insulator to lefthand front fender apron bolts.
