Contour V6-153 2.5L DOHC (1996)
12.
Remove right driveshaft bearing support shield retaining nuts, then the shield.
13.
Remove right driveshaft bearing support bracket retaining bolts from the engine block. Disengage the bracket from the engine block only.
14.
Disconnect alternator electrical wiring.
15.
Remove the serpentine drive belt from the alternator pulley.
16.
Remove the alternator rear bracket retaining bolt.
17.
Remove the alternator mounting bolts, then position the alternator away from the catalyst/exhaust manifold.
18.
Remove the oxygen sensor from the rear (right) catalyst/exhaust manifold.
19.
Disconnect and discard both Differential Pressure Feedback EGR (DPFE) hoses.
20.
Remove the EGR tube from the rear (right) catalyst/exhaust manifold.
NOTE:
The exhaust manifold is attached to the engine with studs and nuts. When removing the nuts, some studs will unscrew from the head.
21.
Remove the retaining nuts from the rear (right) catalyst/exhaust manifold.
22.
Remove the rear (right) catalyst/exhaust manifold from the vehicle.
23.
Remove exhaust manifold gasket.
24. Remove air deflector from under the front bumper.
NOTE:
The exhaust manifold is attached to the engine with the studs and nuts. When removing the nuts, some studs will unscrew from the head.
25.
Remove the retaining nuts from the front (left) catalyst/exhaust manifold.
26.
Remove the front (left) catalyst/exhaust manifold from the vehicle.
27.
Remove exhaust manifold gasket.
Removed Catalysts
Removed catalysts must be returned. An FPS-700 Parts Disposition Tag will be issued to recall the removed catalysts. Return of removed catalysts with
the FPS-700 tag attached must be shipped prepaid freight via United Parcel Service (UPS) to the address on the reverse side of the tag.
Refer to the part return shipping procedure in Section 7.0 of the Warranty and Policy manual.
ANY QUESTIONS ON THE HANDLING OF SPECIAL SITUATIONS REGARDING REMOVED CATALYSTS SHOULD BE RESOLVED WITH
YOUR SERVICE ZONE MANAGER.
Component Transfer
1.
Transfer the oxygen sensor and catalyst monitor from the old front (left) catalyst/exhaust manifold to the new catalyst/exhaust manifold.
2.
Tighten oxygen sensor to 35-46 N-m (26-34 lb/ft).
3.
Tighten catalyst monitor to 35-46 N-m (26-34 lb/ft).
Installation
1.
Install any studs that unscrewed from the head.
2.
Position new manifold gaskets on both heads.
3.
Position new front (left) catalyst/exhaust manifold in the vehicle.
