Contour V6-153 2.5L DOHC (1996)
Clutch Switch: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect battery ground cable.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control
Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
2. Disconnect harness connector from Clutch Pedal Position (CPP) switch.
3. Rotate approximately 45 degrees and pull to remove CPP from bracket.
4. Reverse procedure to install.