Contour V6-153 2.5L DOHC (1996)
3.
Position an adjustable jack stand approximately 25 mm (1 inch) below the center of the rear sub-frame. See Figure 1.
CAUTION
The use of bolts longer than 70 mm (2-3/4 inches) will result in damage to the vehicle floorpan.
4.
Obtain locally two (2) bolts (12 mm x 1.75) between 58 mm and 70 mm (2-9/32 inches and 2-3/4 inches) in length and two (2) flat washers. These
bolts will be used as draw bolts during the lowering and raising of the rear sub-frame.
NOTE:
Marking the location of the sub-frame mounting bolts is necessary for proper alignment of the sub-frame during installation.
5.
Scribe the sub-frame around the perimeter of the four (4) mounting bolts.
6.
One at a time, replace the two (2) rear retaining bolts of the rear sub-frame with the two (2) draw bolts and washers. See Figure 1.
7.
Remove the two (2) front retaining bolts from the rear sub-frame.
8.
Alternately loosen the two (2) draw bolts in 6 mm (1/4 inch) increments to lower the rear sub-frame onto the adjustable jack stand. Then,
completely remove the draw bolts and washers.