Contour V6-153 2.5L DOHC (1996)
Seat Belt Buckle: Service and Repair
Rear Seat Belt Buckle
REMOVAL
1. Remove rear seat cushion.
2. Remove RH rear safety belt and buckle retaining bolt and remove rear safety belt and buckle.
3. Remove LH rear safety belt and buckle retaining bolt and remove rear safety belt and buckle.
INSTALLATION
1. Position safety belts as shown. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
2. Install LH rear safety belt and buckle and LH rear safety belt and buckle retaining bolt. Tighten bolt to 38 Nm (28 lb ft).
3. Install RH rear safety belt and buckle and RH rear safety belt and buckle retaining bolt. Tighten bolt to 38 Nm (28 lb ft).
4. Check the restraint system for proper operation and perform Functional Test Procedure.
