Contour V6-153 2.5L DOHC (1996)
3. Install direct clutch hub and shell on forward/coast/direct clutch cylinder, then slide reverse clutch drum assembly over direct clutch hub and shell.
4. Install reverse clutch hub and retaining ring, then invert assembly and install forward/coast/direct clutch cylinder hub seal on cylinder.
Coast Clutch Piston Seal Sizing
5. Use coast clutch piston seal sizer tool No. T94P-7700-D4 or equivalent to size forward/coast/direct clutch cylinder hub seal. Leave tool in place
until cylinder is installed in transaxle case.
With CD4E
DISASSEMBLE
1. Remove reverse clutch pressure plate retainer snap ring, then the plates.
Reverse Clutch Return Spring Compression
2. Use clutch spring compressor tool No. T65L-77515-A or equivalent to compress reverse clutch return spring, then remove retaining ring with snap
ring pliers.
3. Remove spring compressor tool carefully to release pressure, then remove return spring assembly and piston.
ASSEMBLE
1. Soak internal spline clutch plates in clean transmission fluid for 15 minutes before assembly, then install reverse clutch piston in reverse clutch
piston seal protector tool No. T94P-77000-D2 or equivalent.
