Contour V6-153 2.5L DOHC VIN L SFI (1997)
Front Door Window Regulator: Service and Repair
Removal and Replacement
REMOVAL
1. Disconnect battery ground cable.
NOTE: Procedure also applies to manual window regulator.
2. Remove front door window glass.
3. Loosen, but do not remove front door window regulator-to-front door retaining bolts. (Power windows three bolts, manual windows two bolts.)
4. Remove three window regulator electric drive retaining bolts, if equipped.
5. Slide front door window regulator retaining bolts from slots in front door.
6. Disconnect wiring harness from window regulator electric drive, if equipped.
7. Remove front door window regulator.
INSTALLATION
1. To install, reverse Removal procedure.
2. Tighten front door window regulator-to-front door window glass retaining bolts to 8 Nm (71 in lb).
3. Tighten front door window regulator-to-front door retaining bolts to 5 Nm (44 in lb).
