Contour V6-153 2.5L DOHC VIN L SFI (1997)
19. If necessary, remove the No.18 driven sprocket bearing assembly from transaxle case. Install Threaded Drawbar T75T-1176-A, Servo Plug
Replacer/Needle Bearing Receiver T94P-77000-E2 (part of Needle Bearing Remover/Replacer/Receiver-Servo Plug Replacer T94P-77000-E) and
Needle Bearing Remover/Replacer T94P-77000-E1 (part of Needle Bearing Remover/Replacer/Receiver-Servo Plug Replacer T94P-77000-E).
NOTE: The No.18 driven sprocket bearing assembly can only be replaced once before transaxle case replacement becomes necessary. If the No.
18 driven sprocket bearing has been replaced previously and requires a second replacement, the transaxle case must be replaced.
20. Remove the No. 18 driven sprocket bearing assembly.
Assembly
1. If necessary, install the No.18 driven sprocket bearing assembly in the transaxle case. Install Threaded Drawbar T75T-1176-A, Servo Plug
Replacer/Receiver T94P-77000-E2, and Needle Bearing Replacer T94P-77000-E1.
