ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Recall - Auxiliary Rear Seat Belt Retractor Inspection|Page 5875 > < Recall - Auxiliary Rear Seat Belt Retractor Inspection|Page 5873
Page 3
background image

1.

Examine the right-hand side of the auxiliary rear seat to determine if the seat belt assembly has been installed correctly (Refer to Figure 9, page
41-50-6 of the 1988 Car Shop Manual, Volume A shown below). If the retractor on the right side of the vehicle is installed in the forward location,
both the retractor and buckle must be removed and their positions reversed.

2.

Remove the right side auxiliary seat cushion to gain access to the seat belt bolts. Remove both bolts.

3.

Install the retractor in the rearward anchorage and the buckle end in the forward anchorage. Hand start the bolts and tighten to 30-43 N-m (22-32
ft.lbs.). In the event the threads are stripped, retap to 1/2" and replace the old bolt with a 1/2" - 13 X 1.38 pan head locking bolt, Ford Part No.
383531-S36.

4.

Replace the seat cushion. Check the function of the seat belt retractor.

Suggested Owner & Owner Letter Information

For Areas Not Affected by U.S. Law

Suggested Owner Letter (Dealership Stationery)

SAFETY RECALL 88S42 - INCORRECT AUXILLIARY REAR SEAT BELT RETRACTOR INSTALLATION

Dear Owner:

Ford Motor Company has determined that a defect which relates to motor vehicle safety exists in certain 1987 and 1988 Ford Crown Victoria and
Mercury Grand Marquis eight passenger station wagons.

Safety Defect

The seat belt assembly for the side facing, auxiliary rear
seat an the right-hand side of the vehicle may not have been installed correctly. Because of this, the belt webbing could be
pinched between the seat cushion and seat back and the seat belt could be prevented from retracting and fitting snugly. A
loose seat belt may not provide as much protection to an occupant as a snug belt in the event of a vehicle crash.

Warning

Do not allow the right-hand, side facing rear seat to be
occupied until the seat belt has been serviced.

Repairs

At no cost to you, we will inspect and, if necessary, install
the seat belt correctly.

How Long Will it Take?
The time needed to repair your car is less than one hour.
Call For An Appointment
Call us without delay and ask for a service date. We have the service information needed to repair your car.

Recall - Auxiliary Rear Seat Belt Retractor Inspection|Page 5875 > < Recall - Auxiliary Rear Seat Belt Retractor Inspection|Page 5873