Crown Victoria V8-281 4.6L SFI (1998)
become damaged.
6.
Remove the jackscrews and the 2X6 block from under the vehicle.
7.
Clip the ground strap to the #6 body holes on the frame on the right and left hand.
8.
Reinstall the # 2, 3, 4, 5, and 6 body mount bolts on both sides.
9.
Torque bolts to 48-50 N.m (35.4-36.8 lb-ft).
10.
Partially lower the vehicle to waist height.
11.
Relocate the bumper fascia and four (4) bumper cover nuts (two (2) on each side).
12.
Torque bolts to 7 N.m (61.9 lb-in) (Figure 3 shows left hand side).
13.
Reposition trunk trim sides.
14.
Partially raise the vehicle.
15.
Replace the six (6) pin-type retainers (three (3) on each side) in the wheel well leading edge of the bumper (Figure 8) and the push pin-type
retainers (two (2) or three (3) on each side) from bottom sides of bumper cover (Figure 7).
16.
Partially lower the vehicle.
17.
Replace the rear wheel and tire assemblies.
18.
Lower the hoist.
19.
Close the trunk.
20.
Reconnect the battery per Workshop Manual: Section 414-01.
21.
Close the hood.
