Removal Procedure for Camshaft in Crown Victoria V8-281 46L SFI (1998) Engine - Page 2132
17. Install stud bolts and bolts retaining engine front cover to engine. Tighten in sequence shown to 20-30 Nm (15-22 ft. lbs.).
NOTE: Engine front cover must be installed and retaining bolts and stud bolts tightened to specification within five minutes of applying sealant.
18. Apply Silicone Gasket and Sealant F6AZ-19562-AA or equivalent WSE-M4G320-A6 to both places where the engine front cover meets cylinder
head.
NOTE: Remove all traces of dirt, oil or previously applied sealant. Clean all sealing surfaces with Metal Surface Cleaner F4AZ-13A536-RA or
equivalent. Sealing surfaces must be clean and dry before applying sealant.
19. Position and, using Silicone Gasket and Sealant F6AZ-19562-AA or equivalent, secure gaskets into valve covers and install valve covers onto
cylinder heads.
20. Install bolts and stud bolts into RH valve cover. Tighten all bolts to 8-12 Nm (71-106 inch lbs.).
NOTE: Valve covers must be installed and tightened within five minutes of applying sealant.
