Crown Victoria V8-281 4.6L SFI (1998)
25.
Detach two (2) wiring harnesses from clip on left rear of intake manifold. See Figure 7. Push both harnesses toward bulkhead clearing intake
manifold.
26.
Disconnect Throttle Position (TP) sensor electrical connector.
27.
Disconnect Idle Air Control (IAC) motor electrical connector.
28.
Unclip fuel charge wiring harness from studs on left side valve cover. Position wiring harness away from intake manifold. See Figure 8.
29.
Remove intake manifold retaining bolts.
30.
With an assistant's help, remove intake manifold assembly.
Installation
1.
Transfer all necessary components to new intake manifold.
2.
Clean intake manifold to cylinder head gasket surface.
3.
Install new intake manifold gaskets.
