Crown Victoria V8-281 4.6L SFI (1998)
2.
Disconnect ABS module electrical connectors. Refer to Figure 1.
3.
Remove four (4) retainers securing ABS module to Hydraulic Control Unit (HCU). See Figure 1.
4.
Remove ABS module from vehicle.
5.
Install new ABS module into vehicle.
6.
Install four (4) retainers securing ABS module to Hydraulic Control Unit (HCU). Tighten retainers to 1.8-2.8 Nm (16-25 lb/in).
7.
Connect ABS module electrical connectors.
8.
Connect battery negative cable, then remove memory saver.
