Crown Victoria V8-281 4.6L SFI (1998)
Evaporative Emission Control Canister: Service and Repair
1. Raise vehicle on hoist.
2. Remove evaporative emission canister retaining nuts and bolts.
3. Partially lower Evaporative Emissions canister (EVAP canister) and disconnect the wiring harness attachment.
4. Loosen clamp on fuel tank vent tube. Remove clips on canister hoses from underbody. Disconnect left canister hose from evaporative emission
vent hose. Disconnect right canister hose from fuel tank vent tube.
5. To install, reverse removal procedure. Tighten evaporative emission canister retaining nuts to 7.6-10.4 Nm (68-92 lb in). Perform system leak
check. See: Testing and Inspection/Component Tests/EVAP System Leak Test
6. Perform the Evaporative Emission Running Loss Monitor Repair Verification Drive Cycle. See: Testing and Inspection/EVAP Running Loss
System Repair Verification
