Crown Victoria V8-281 4.6L SFI (1998)
Camshaft Position Sensor: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect engine control sensor wiring from Camshaft Position sensor (CMP sensor).
3. Remove camshaft position sensor retaining screw and remove camshaft position sensor from engine front cover.
INSTALLATION
1. Make sure camshaft position sensor mounting surface is clean and that camshaft position sensor O-ring is in proper location on camshaft position
sensor.
2. Position camshaft position sensor and install retaining screw. Tighten to 8-12 Nm (71-106 lb in).
CAUTION: Do not overtighten camshaft position sensor retaining screw or damage to camshaft position sensor may occur.
3. Connect engine control sensor wiring to camshaft position sensor.
4. Connect battery ground cable.
