Crown Victoria V8-281 4.6L SFI (1998)
2. Insert Safety Belt Bolt Bit 501-010 (T77L-2100-A) and remove the front safety belt guide hex flange retaining nut.
3. Remove front safety belt anchor-to-sill bolt.
4. Remove center body pillar inside upper finish panel.
5. Remove front safety belt guide and screw from B-pillar.
6. Remove front safety belt retractor bolt.
7. Remove front safety belt retractor and tongue from vehicle.
INSTALLATION
1. Position front safety belt retractor and tongue in vehicle. Make sure safety belt webbing is not twisted. If it is, remove the twist.
2. Install front safety belt retractor bolt. Tighten bolt to 34-46 N.m (25-33 Lb-Ft).
3. Install safety belt guide and screw to B-pillar.
4. Install center body pillar inside upper finish panel.
5. Install front safety belt anchor-to-sill bolt. Tighten bolt to 34-46 N.m (25-33 Lb-Ft).
6. Check condition of front seat shoulder strap guide cover. If not in good condition, replace with new part. Position lower portion of front seat
shoulder strap guide cover over front safety belt guide and snap into position.
7. Install front safety belt guide hex flange retaining nut. Tighten nut to 34-46 N.m (25-33 Lb-Ft).
8. Gently push upper flap of front seat shoulder strap guide cover down until it snaps onto the front safety belt guide.
9. Check the restraint system for proper operation and perform Functional Test Procedure. See: Testing and Inspection/Component Tests and
General Diagnostics
Retractor and Tongue - Rear Seats
REMOVAL
1. Remove rear seat cushion kit.
2. Remove rear safety belt anchor nut.
3. Remove roof side rear quarter trim panel.
4. Remove rear safety belt opening grommet and pull rear safety belt retractor and tongue through belt opening in the quarter trim panel.
5. Remove rear safety belt retractor bolts.
6. Remove outboard rear safety belt retractor and tongue from the vehicle.
INSTALLATION
1. Position rear safety belt retractor and tongue in vehicle. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
2. Install two rear safety belt retractor bolts. Tighten bolts to 34-46 N.m (25-33 Lb-Ft).
