Crown Victoria V8-281 4.6L SFI (1998)
NOTE: Since the BPP switch side plate nearest the brake pedal is slotted, it is not necessary to remove the brake master cylinder push rod and
one spacer washer from the brake pedal pin.
INSTALLATION
1. Position BPP switch so that the U-shaped side is nearest the brake pedal and directly over or under the pin. Then slide BPP switch down or up
trapping the master cylinder push rod and black bushing between the stoplight switch side plates. Push BPP switch and push rod assembly firmly
toward brake pedal arm. Assemble outside white plastic washer to pin and install hairpin retainer to trap whole assembly.
CAUTION: Do not substitute other types of pin retainers. Replace only with a production hairpin retainer. Component damage may occur.
2. Assemble the wire harness connector to the BPP switch.
NOTE: BPP switch wire harness must have sufficient length to travel with BPP switch during full stroke of brake pedal. If wire length is
insufficient, reroute harness or replace as required.
3. Check BPP switch for proper operation.
