Crown Victoria V8-281 4.6L SFI (1998)
12.
Using a 25/64 inch drill bit, drill a hole at each inertia switch mounting bolt location. See Figure 5.
13.
Clean all metal shavings from luggage compartment.
14.
Install new inertia switch bracket with mounting tab on top and elongated hole facing down. See Figure 6. Tighten bolts to 9 Nm (6.6 lb-ft).
15.
Using original screws, install inertia switch assembly on bracket.Tighten screws to 3 Nm (2.2 lb-ft).
16.
Install wiring harness routing pushpins.
17.
Press reset button on inertia switch. Make sure switch is set properly.
18.
Reposition carpet back on left inner quarter panel.
19.
Install carpet pushpins.
20.
Close trunk.
