Crown Victoria V8-281 4.6L SFI (1998)
10. Apply an even bead of Urethane Adhesive WSB-M2G316-B around entire sheet metal pinch weld on top of existing bed of urethane. The bead
should be triangular in shape, 16 mm (0.63 inch) high and 8 mm (0.3 inch) at base.
NOTE
-
Leave a door window slightly open until adhesive is cured.
-
Apply new urethane on top of existing material on pinch weld.
11. Install back window assembly onto vehicle, taking care to align marks on glass and body. This must be done before adhesive skins over.
CAUTION
-
When replacing urethane-installed glass parts, do not drive the vehicle until the urethane has cured. At 21°C (70°F) and 50% relative
humidity, adequate cure time is typically 24 hours (less at higher temperatures and higher humidities). See detailed instructions provided by
the urethane manufacturer. Inadequate or improper curing can adversely affect the retention of the back window.
-
Use only urethane for service of air and water leaks in urethane-set back windows.
12. Tuck finisher strip on window moulding along the side under the ditch moulding.
13. Reconnect antenna and rear window defroster wires.
14. Remove spacer and install headliner. Install all garnish mouldings.
15. Install panel.
16. Check installation for air and water leaks in urethane seal.
